AMEYA360:Renesas Electronics RZ/G2UL SMARC Kit

发布时间:2023-03-23 13:48
作者:AMEYA360
来源:网络
阅读量:2454

  Renesas Electronics RZ/G2UL SMARC Kit evaluates the RZ/G2UL General-Purpose Microprocessors. The Renesas Electronics RZ/G2UL kit includes a module board (SOM) and a carrier board. The carrier board is used with RZ/G2L, RZ/G2LC, and RZ/V2L modules (SOM) and prepared according to the SMARC v2.1 standard. This board allows seamless and flexible evaluation between devices.

AMEYA360:Renesas Electronics RZ/G2UL SMARC Kit

  FEATURES:

  Carrier Board Function

  The FFC/FPC connector is mounted as standard for connection to the high-speed serial interface for the camera module

  The Micro-HDMI connector via DSI/HDMI conversion module is mounted as standard for connection to a high-speed serial interface for the digital video module

  The Micro-AB receptacle (ch0: USB2.0 OTG) and A receptacle (ch1: USB2.0 Host) are respectively mounted as standard for connection to the USB interface

  The RJ45 connector is mounted as a software development and evaluation standard using Ethernet

  The audio codec is mounted as a standard for advanced audio system development

  The audio jack is implemented for connection to an audio interface

  The Micro-AB receptacles are implemented for connection to the asynchronous serial port interface

  The microSD card slot and two sockets for PMOD are implemented as an interface for peripheral functions

  For the power supply, a mounted USB Type-C? receptacle supports the USB PD standard

  Device RZ/G2UL (Type-1)

  Arm? Cortex?-A55 Single, Arm Cortex-M33

  BGA361pin, 13mmSq body, 0.5mm pitch

  Module board function

  DDR4 SDRAM 1GB × 1pc

  QSPI flash memory 128Mb × 1pc

  eMMC memory 64GB × 1pc

  The microSD card slot is implemented and used as an eSD for boot

  5-output clock oscillator

  PMIC power supply

  ADDITIONAL RESOURCES:

  RZ/G2UL Power Consumption Measurement

  RZ SMARC Series Carrier Board User's Manual: Hardware

  RZ/G2UL, RZ/A3UL, RZ/Five SMARC Module Board User's Manual: Hardware


(备注:文章来源于网络,信息仅供参考,不代表本网站观点,如有侵权请联系删除!)

在线留言询价

相关阅读
AMEYA360:Novosense Optocoupler Compatible Single-channel Isolated Gate Driver
  NSi6801 is an isolated gate driver with single-channel optocoupler-compatible input, which can be used to drive IGBT, SiC and MOSFET. It can provide peak source/sink current of 5A/5A. It supports the minimum common mode transient immunity (CMTI) of 150kV/μs, which ensures the robustness of the system.      The maximum power supply voltage of the driver is 32V. It has performance advantages over optocoupler gate drivers, including better reliability and aging performance, higher operation temperature, shorter propagation delay and less pulse width distortion. Therefore, NSi6801 is more suitable than photoelectric isolation driver in switching power supply systems, , photovoltaic inverters and motor drive systems which requires high reliability, high power density and high efficiency.  Product Features:  P2P compatible with optocoupler drivers, but upgraded performance  Driver side power supply voltage: up to 32V, UVLO is available  Peak source/sink current: 5A/5A  High CMTI: 150kV / μs  Typical propagation delay: 75ns  Maximum pulse width distortion: 30ns  Operation ambient temperature: -40℃~125℃  RoHS compliant package:  SOW6  DUB8  Safety Certificate:  UL1577 certification:  SOW6: 5.7kVRMS for 1min.  DUB8: 5kVRMS for 1min.  DIN VDE V 0884-11:2017-01  CSA component notice 5A  CQC certification per GB4943.1-2011  Application:  PV inverter  Energy storage  Servo motor  Frequency converter
2023-05-17 10:51 阅读量:2450
AMEYA360:Experts Weigh Impact of Intel-Arm Collaboration
AMEYA360:ASML Ban Affects China’s Advancement in Chips
  As part of an agreement between the U.S. government, the Netherlands, and Japan, ASML, Nikon, and Tokyo Electron won’t be supplying their high-end photolithography equipment to Chinese companies.  According to the Wall Street Journal, “the Netherlands will bar ASML Holding NV, a Dutch maker of photolithography machines, from selling to China at least some immersion lithography machines, the most advanced kind of gear in the company’s deep ultraviolet lithography line.”  ASML manufactures all of the world’s extreme ultraviolet lithography machines, which are critical for producing cutting-edge semiconductors.  China could easily circumvent the export bans for advanced semiconductors, as it has been doing for many years. Acquiring huge lithography machines is much more difficult, and making them from scratch is nearly impossible. Furthermore, only a few hundred of those machines are sold every year, making it much easier to control their destination.  ASML bans chip making equipment to China  It is unknown how much of that critical equipment has already been sold to China and what capacity Chinese companies already have to produce the most advanced semiconductors.  While China is unlikely to have the technology to produce sub-10nm chips, it is already investing in new fabs. Currently, only Taiwan’s TSMC can produce 5nm technology. To do that, it requires the advanced lithography machines that ASML has.  Lithography in the U.S.  A lithography system is a projection system. Light is projected through a blueprint of the pattern to print (known as a ‘mask’ or ‘reticle’). This process will be repeated 100 times or more, laying patterns on top of patterns to make a complete microchip.  This crucial technology was discovered in 1957 by Jay Lathrop and James Nall, of the U.S. Army’s Diamond Ordnance Fuse Laboratories in Maryland. They patented the photolithographic techniques used to deposit thin-film metal strips about 200 micrometers wide to connect discrete transistors on a ceramic substrate.  In 1959 Lathrop joined Texas Instruments, and Nall went to Fairchild Semiconductor. In 1958, engineers at Fairchild built one of the first “step-and-repeat” cameras to easily copy and multiply transistors on a single wafer using photolithography.  In the early 1980s, GCA Corp. was considered the worldwide leader in photolithography and celebrated as one of the “hottest high-technology companies.” They invented the wafer stepper (the step-and-repeat camera), a device similar to a slide projector or a photographic enlarger, enabling further reductions in chip size. It was the first technology to exceed the 1-micron limit.  At the time, Japanese competitors Nikon and Canon were catching up quickly and making bold technological investments. While American lithography companies were holding back in capital expenditures until they had a deal with semiconductor manufacturers, the Japanese worked hand-in-hand with them to define roadmaps and coordinate the delivery of new equipment.  “It was impossible to make semiconductors without lithography tools, but the only remaining U.S. producers were struggling to survive,” wrote Chris Miller in Chip War: The Fight for the World’s Most Critical Technology.  In 1993, after receiving at least $60 million in funds from the government-backed Sematech consortium, GCA closed its factory in Massachusetts as it could not compete with ASML, Nikon, and Canon.  ASML can’t meet demand  While other lithography manufacturers can print 10nm patterns, ASML’s EUV (extreme ultraviolet) technology enables the scale of the smallest feature to be reduced below that limit. That’s why they hold 100 percent of the market for the most advanced lithography machines.ASML Ban Affects China’s Advancement in Chips  Recently, ASML reported revenues of $23 billion and $6.05 billion in net income for FY2022. The Dutch company sold 317 new and 28 used lithography systems to their customers. They expect an increase of 25 percent in net sales for FY2023.  “For 2023, ASML expects continued strong growth with a net sales increase of more than 25 percent and a slight improvement in gross margin, relative to 2022. We expect first-quarter net sales between €6.1 billion and €6.5 billion with a gross margin between 49 percent and 50 percent,” said ASML President and CEO Peter Wennink.  The new restrictions on exporting equipment to China won’t hurt the company’s bottom line, as the demand from Taiwan, Europe, and the U.S. will continue to grow.  China might retaliate  Chip-making equipment is critical for China’s ambitions to lead in artificial intelligence and quantum computing technologies.  While it would be possible for large Chinese companies to source state-of-the-art chips and build new systems abroad, not being able to design and manufacture advanced semiconductors in mainland China is a step back in their ambitions.  The Chinese government has not issued any comment yet on the new restrictions, but it will likely react. One possibility is trade restrictions on Western businesses.
2023-05-11 11:05 阅读量:2598
AMEYA360:Avnet Fiscal Q3 Sales Up 0.4%
  Avnet, Inc. (Nasdaq: AVT)  announced results for its third quarter ended April 1, 2023.  Commenting on the Company’s financial results, Avnet Chief Executive Officer Phil Gallagher stated, “I am pleased with our results this quarter as our team delivered another quarter of year-over-year sales and operating margin growth. We delivered record quarterly operating income in our Electronic Components business to help us achieve our stated goal of 5% operating margin. I am proud of our team’s dedication and commitment to continuously execute and deliver value to our customer and supplier partners.”  Fiscal Third Quarter Key Financial Highlights:  Sales of $6.5 billion up 0.4% year over year from $6.5 billion.  On a constant currency basis, sales increased 3.4% year over year.  Diluted earnings per share increased to $2.03, compared with $1.84 in the prior year quarter.  Adjusted diluted earnings per share of $2.00, compared with $2.15 in the prior year quarter.  Higher interest expense and foreign currency exchange rates negatively impacted year over year adjusted diluted earnings per share by $0.37 and $0.09, respectively.  Operating income margin of 4.8%, increased 58 basis points year over year.  Adjusted operating income margin of 4.8%, increased 15 basis points year over year.  Year over year adjusted operating income grew more than two times greater than sales in constant currency.  Electronic Components operating income margin of 5.0%, increased 64 basis points year over year, and increased 34 basis points sequentially.  Farnell operating income margin of 9.0% was flat sequentially.  Generated $18.3 million of cash flow from operations during the quarter.  Returned $26.5 million to shareholders in dividends during the quarter.  The full release and tables can be found here. 
2023-05-11 10:59 阅读量:2490
  • 一周热料
  • 紧缺物料秒杀
型号 品牌 询价
TL431ACLPR Texas Instruments
CDZVT2R20B ROHM Semiconductor
MC33074DR2G onsemi
BD71847AMWV-E2 ROHM Semiconductor
RB751G-40T2R ROHM Semiconductor
型号 品牌 抢购
BP3621 ROHM Semiconductor
ESR03EZPJ151 ROHM Semiconductor
STM32F429IGT6 STMicroelectronics
TPS63050YFFR Texas Instruments
BU33JA2MNVX-CTL ROHM Semiconductor
IPZ40N04S5L4R8ATMA1 Infineon Technologies
热门标签
ROHM
Aavid
Averlogic
开发板
SUSUMU
NXP
PCB
传感器
半导体
相关百科
关于我们
AMEYA360微信服务号 AMEYA360微信服务号
AMEYA360商城(www.ameya360.com)上线于2011年,现 有超过3500家优质供应商,收录600万种产品型号数据,100 多万种元器件库存可供选购,产品覆盖MCU+存储器+电源芯 片+IGBT+MOS管+运放+射频蓝牙+传感器+电阻电容电感+ 连接器等多个领域,平台主营业务涵盖电子元器件现货销售、 BOM配单及提供产品配套资料等,为广大客户提供一站式购 销服务。